Fig. A:
(*) Place the TOP CASE bottom rack (1) in the assembly
position(*)on the motorcycle original packet-holder, fit the
anchoring flanges (2) under the most suitable tubes or supports
and secure using the screws (3), the rectangular washers(4),
the flanges (2), the washers (5) and the nuts (6). Fig. B on the
SHAD anchoring:
Situate the bottom rack of the TOP CASE (1)
in
the assembly position, remove the fastening clips (2), fasten
with
screws (7),the rectangular washers (4), the washers (5)
and the nuts (6). Tighten all the screws and nuts.
Fig. A
2
1
7
4
5
6
.tnaC.feR.soP
16051021
49401022
4)569 NID 04x6M( 4414033
4 2/3170024
4)6Ø( 0003035
4)6M( 1202036
4)569NID 03x6M( 8504037
1 805102/7051028
Fixation SHAD
PARTS
2.
Rack D1B40PA
11
12
10
9
8
Then fit the covers (8) by bending it slightly to insert the tongues
(Fig. C).
It can only be used on the Top or Full master.
Included in the specific support.
10
9
Fig. D
Fig. E
PARTS
.tnaC.feR.soP
4* 4051029
4** )219 02x8M( 47040301
4** )8Ø( 02030311
4** )8M( 42020321
Fig. C
3.
1
2
3
4
5
6
Fig. B
500791/1 user guide SH40_42_45_46 15/08/16 17:00 Página 3
To Next Page
Loading...
