Power On/Off
1. Firstly connect power cord and analog inputs. Then press the main power switch on the back of amplifier
to ON position. Power indicator on front panel will light up, now you can press the Standby button on
front panel or remote [ ] to fully turn on the amplifier.
Input switching
Volume control
Output protection
Gain adjustment
Mode selection
Mute function
13
A3.2
INTEGRATED AMPLIFIER
Operation Instructions
2. To turn off the amplifier, press the [ ] button on amplifier or remote. Then set the main power switch on
the back of amplifier to off position.
3. If the amplifier is not used for a longer time, it's recommended to disconnect power cord.
Press the [IN- / IN+] buttons on front panel or [ INPUT ] on remote to switch between different inputs.
Active input will be shown on the multifunctional display.
Press the [VOL-/VOL+] buttons on front panel or [VOLUME-/+] on remote to adjust volume. Current volume
will be shown on the multifunctional display.
When the output of the amplifier is overloaded, a protection relay will be automatically disconnected
immediately. Multifunctional display will show "PROTECT" message. Immediately turn off the main power
switch, to prevent any further damage. Please wait at least 5 minutes before trying to restart the amplifier.
Set the amplifier gain accordingly for your connected sources and speakers. "HIGH GAIN" is recommended
for low sensitive speakers and weak sources. "LOW GAIN" is recommended for high sensitive speakers or
high output sources.
Switch between different use modes of the Amplifier.
(Note: Amplifier needs to be restarted after switching mode)
1. Press the [MUTE] button on front panel or remote, display shows "MUTING". Output is muted.
2. Press the [MUTE] button again to resume normal playback. Please check the volume level before
unmuting the output.
To Next Page
Loading...
