What to do if the Shannon HR 220-300 Cutter display is empty?
If the display on your Shannon Cutter is empty, the most likely cause is a lack of power. Here's what you should do: first, alert a maintenance engineer. Then, check the fuse. Also, inspect the power supply cable. If these steps don't resolve the issue, contact the supplier.
What to do if Shannon Cutter shows error E2?
If the Shannon Cutter shows error code E2, it indicates a loose wire or spark detection issue. To resolve this, check the filament connection, check the filament, and reset the machine. You can also reset this fault using the arrow down button.
What to do if Shannon HR 220-300 Cutter shows error E1?
If your Shannon Cutter displays error code E1, it means the wire is loose. You should turn off the machine, check the filament, and then reset it. Note that this fault cannot be detected between the values 00 and 04.
Diagram and labels for machine components.
Instructions for placing and setting up the device.
Steps to connect the device to the power supply.
Steps to prepare the machine before operation.
Instructions for turning on the heating element.
Guide on how to adjust the heating element temperature.
Identifies error messages and their solutions.
Safety steps before adjusting the heating element.
Instructions for adjusting the filament height.
Safety steps before performing maintenance.
Advice on cleaning the heating element for efficiency.
Safety steps before tensioning or changing the filament.
Step-by-step guide to tensioning the filament.
Detailed instructions for replacing the filament.
Safety steps before replacing fuses.
Procedure for checking and replacing control unit fuses.
List of spare parts with values for different models.
Details on accessories like reducing sets, foil profiles, and moulds.
Information on flame polishing and diamond polishing machines.
Specifications for HR, HRT, HRK, HRP bending machines.
Specifications for HRT/D, HRP/D, FBM bending machines.
Details on the one-year warranty for parts, call-out, and labour.
To Next Page
General