Accessories
Fitting the snap-in sewing table
1.Keep the snap-in sewing table
horizontal, and pull it out from
the machine as photo(1)
2.The bobbin holder and accessory
bag are put into the inside of the
sewing table.
3.Pull the side cover to open it as
photo (2)
1
2
3
Blind hem
1.Fold the fabric as
illustrated in figure (1)
2.Place
the fabric under
the foot. Turn the
handwheel
forwards
until
the needle sewings
to
the left.It should just
picrce
the fold of the
fabric. If it doesn’t ,
reposition
the fabric
under the foot.(2)
3.Sew
slowly, guiding the
fabric carefully
4.After sewing ,open the
fold and press with an
iron.
3-step zig-zag
1.Sewing on lace and
elastic,patching,mending,
reinforcing edges.
2.Set machine as illustrated.
3.Place patch in position and
sew around the edges.
4.When mending tears,it is
advisable to use a piece
of backing fabric
to reinforce.
5.Fisrst
sew over the center
and then overlap on both
sides. Depending on the
type
of fabric and damage,
sew between 3 and 5 rows.
12
9 10
8
Foot control
Adaptor
Brush
Screwdriver
Buttonhole foot
Zipper
foot
Button sewing
plate
Regular sewing
foot
Twin needle
Needles (x2)
Threader
Spool pin
Bobbins (x2)
To Next Page
Loading...
