sharkclean.com/AIRobotSEsharkclean.com/AIRobotSE
USING THE SHARK AI ULTRA 2-IN-1 ROBOTUSING THE SHARK AI ULTRA 2-IN-1 ROBOT
VAC & MOP 2-IN-1 SETUPVAC & MOP 2-IN-1 SETUP
Secure the pad to the Vac & Mop 2-in 1 Dust Bin.
Lift open the fill cap on the top of the reservoir. Fill
with water to the WATER FIRST line then fill the
VACMOP™ cleaning solution to the VACMOP CLEANER
line. Close the cap and make sure it is properly sealed.
Avoid filling with the cleaning solutions other than
the recommended ones above. This may hinder the
cleaning performance of your robot in mopping mode.
Attach the mop pad by inserting the flat edge of the
pad through the slot in the Vac & Mop 2-in-1 Dust Bin.
Pull the mop pad all the way through the slot until it is
securely inserted.
NOTE: Before it can mop, the robot MUST complete an Explore Run with the Self-Empty Dust Bin attached. After
the Explore Run, you will have an option to set up Carpet Zones and verify those carpets in the app with a Carpet
Verification Run. This ensures your robot will avoid carpets in mopping mode.
Firmly push the Vac & Mop 2-in-1 Dust Bin into the
back of the robot, and ensure both latches click
into place. The water droplet icon on the robot will
illuminate white when the Vac & Mop 2-in-1 Dust Bin is
inserted properly.
When the reservoir in the Vac & Mop 2-in-1 Dust Bin
has fluid and is properly installed, with the mop pad
attached, the robot is ready to vacuum and mop
simultaneously. Press the Clean button on the robot or
in the app to start a vacuuming and mopping run. The
robot will prime the mop pad for 30 seconds before
starting its run.
When mopping is complete, remove the Vac & Mop
2-in-1 Dust Bin by pressing the fill port button and
sliding it out. Empty the reservoir after each use and
manually clean out the dust bin.
CAUTION: Floors may be slippery after mopping.
To prevent your robot from traveling over rugs and
carpets in mopping mode, set up Carpet Zones in
the app.
To remove the mop pad from the Vac & Mop 2-in-1
Dust Bin, detach the pad from the reservoir and slide
the pad out of the slot.
NOTE: When mopping, your robot may travel over floor mats or rugs. Before the next mopping run, move
rugs or mats out of the robot’s path, or use the app to set up Carpet Zones or no-go zones.
To Next Page
Loading...
Need help?
General
