11sharkclean.co.uk10 sharkclean.co.uk
CLEANING WITH CARPETXPERT
DEEP CLEANING with the brushroll:
Uses Deep Clean Pro cleaning solution and water
Important: Vacuum with traditional vacuum cleaner first.
1.
Move the selector lever to UP position to engage the floor nozzle.
2.
Gently step on the base and tilt the handle back.
3.
Press power button; unit will enter ‘Deep Clean’ Mode.
4.
Move unit forward slowly; it will automatically dispense water
and Deep Clean Pro cleaning solution.
5.
On the backpass, the unit will use suction to extract liquid
and aid the drying process.
6.
Repeat steps 4 and 5.
7.
Once deep clean is complete, press the Mode button, to activate Dry Only mode.
Repeat passes over the entire cleaning area multiple times to help to reduce dry time.
STAIN CLEANING with the hand tool:
Uses Deep Clean Pro Cleaning Solution + OXY Multiplier
1.
With the unit in upright position, move the selector lever
DOWN until it clicks into place.
2.
Add the desired tool to the crevice tool.
3.
To clean wet messes with the hand tool, first use suction
only to remove liquid.
4.
Then, spray stained area, scrub using bristles, then use
suction until mess is clean and water is extracted.
5.
If your model comes with the Shark® Pet stain trapping tool, use it to
extract liquid messes until the cup is full, then remove the cup and
discard the mess.
Note: Dry time can be impacted by carpet type, climate and cleaning conditions. Dry
time will vary.
Dry Time Tip: Avoid over-cleaning carpet to ensure faster dry times. See Page 14 for
more information on best practice for quicker dry times.
Tip: You may need to repeat cleaning to remove difficult stains.
HANDTOOL USAGE
PET STAIN TRAPPING TOOL
Tip: Avoid over saturating the area, or continual spraying during cleaning.
Tip: Always ensure to use the correct solution dilution measures when setting up the unit for cleaning.
Tip: Choosing the bristles - The rubber bristles are best suited for more delicate surfaces and
upholstery. The tough bristles are ideal for stubborn agitation on hard wearing surfaces.
For best results on wet and dry stains follow the below steps.
Before beginning, turn the unit on.
Spray the stained area using the trigger
on the underside of the handtool. For
older stains, leave to settle.
SPRAY
For wet messes, scrub the stain area
first and then suction up the excess
liquid.
SUCTION
SUCTION
Tilt the handtool forward and drag
it across the stain to extract. Repeat
steps if needed.
Wet
stains
Dry
stains
Scrub the stain with the bristles,
agitating in multiple directions.
SCRUB
The Shark Pet Stain Trapping Tool is included with select models. This extracts unhygienic messes, preventing
the mess from reaching the hose and the interior of the unit. DO NOT use the tool to remove pet hair. To use,
spray the wet mess, then extract it as advised above. To avoid oversaturating, do not over spray. DO NOT exceed
the MAX FILL line on the Pet Tool Cup.
Keep the tool level, without tipping to prevent the mess from reaching the hose. After use, turn off the power of
the main unit and empty the tool cup where appropriate. Wash the cup, filter, and the rest of the tool thoroughly
with soap and water after each use.
fig. 1
fig. 2
Filter
To Next Page
Loading...
