13sharkclean.co.uk12 sharkclean.co.uk
Filter
Door
Release
EMPTYING THE DUST CUP
To remove Dust Cup, press release button on
top of the pod� Tilt dust cup away from wand,
then lift to remove�
To reinstall, place bottom of dust cup into
pod and then tilt until it clicks into place�
To empty debris into the bin, press lower
release button and bottom of dust cup will
drop open�
To remove collected debris from Lint Screen,
press top release buttons either side of the
handle and lift handle to access screen�
CLEAN POST MOTOR FILTER EVERY YEAR
Lie unit flat on the floor so you can see the post motor filter underneath� With the dustcup
removed, press button on filter housing and pull forward� Remove post motor filter by pressing
black tab until it clicks and is released from the unit� To reinstall, insert the filter into the unit by
clicking into place and re-attach the filter housing�
Regularly wash, dry and replace the filters
to maintain your vacuum’s suction power.
To prevent damage from cleaning chemicals,
rinse filters with cold water only� Allow all
filters to air-dry for at least 24 hours before
reinstalling them to prevent liquid from being
drawn into electric parts�
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
IMPORTANT: DO NOT use soap when
cleaning the filters�
IMPORTANT: Unplug the cord before performing any maintenance�
NOTE: The pre-motor filters should be replaced every 2�5 years� The post-motor filter should be replaced every 3 years�
NOTE: Empty the dust cup when or before the debris reaches the max fill line�
Filter
Filter
Housing
CLEAN PRE-MOTOR FILTERS EVERY MONTH
Remove Dust Cup, then lift out Filters�
To Next Page
Loading...
Need help?
General
