To Next PageTo Next PageWhy does my Shark EP754 Vacuum Cleaner motor run but have no suction?
If your Shark Vacuum Cleaner motor is running but there's no suction, it could be due to a few reasons. First, check the hose, wand, or inlet for any blockages and remove them. Second, the HEPA dust bag might be full, so replace it. Lastly, ensure the hose clamp is correctly assembled to the hose inlet until you hear a 'snap' sound, indicating proper assembly.
What to do if my Shark EP754 won't run?
If your Shark Vacuum Cleaner won't run, first, make sure it's firmly plugged into the outlet. Then, check if there's electricity in the wall outlet by testing another device. If the fuse is blown or the breaker is tripped, replace the fuse or reset the breaker. Finally, the motor thermostat may have tripped; turn the vacuum off, unplug it, and allow it to cool down before trying to switch it on again.
How to fix a Shark EP754 Vacuum Cleaner cord that won't rewind?
If your Shark Vacuum Cleaner cord won't rewind, try pulling the cord out, straightening it, and then rewinding it again. If that doesn't work, it's possible the cord was pulled out too far, beyond the red mark. In that case, hold the plug, press the rewind button, and try rewinding again.
Instructions for putting together the vacuum cleaner and its parts.
Steps to connect the flexible hose to the main vacuum unit.
Procedure for correctly installing the HEPA dust bag into the vacuum.
Guide to connecting the telescopic tube to the hose handle.
How to adjust and extend the telescopic tube for use.
Instructions for attaching and using the power nozzle.
How to adjust the vacuum's suction power for different tasks.
General guide on operating the vacuum cleaner.
Explanation of the dust bag full indicator and its function.
Information about the motor's overheat protection and reset procedure.
Step-by-step guide for replacing the HEPA dust bag.
Instructions for replacing and cleaning the pre-motor and post-motor filters.
Troubleshooting steps for when the motor runs but there is no suction.
Solutions for problems with the automatic cord rewind feature.
Steps to take if the vacuum cleaner does not turn on.
Contact information for technical assistance with the vacuum cleaner.
Instructions for putting together the vacuum cleaner and its parts.
Steps to connect the flexible hose to the main vacuum unit.
Procedure for correctly installing the HEPA dust bag into the vacuum.
Guide to connecting the telescopic tube to the hose handle.
How to adjust and extend the telescopic tube for use.
Instructions for attaching and using the power nozzle.
How to adjust the vacuum's suction power for different tasks.
General guide on operating the vacuum cleaner.
Explanation of the dust bag full indicator and its function.
Information about the motor's overheat protection and reset procedure.
Step-by-step guide for replacing the HEPA dust bag.
Instructions for replacing and cleaning the pre-motor and post-motor filters.
Troubleshooting steps for when the motor runs but there is no suction.
Solutions for problems with the automatic cord rewind feature.
Steps to take if the vacuum cleaner does not turn on.
Contact information for technical assistance with the vacuum cleaner.
General| Model Number | EP754 |
|---|---|
| Type | Upright |
| Voltage | 120V |
| Filtration | HEPA |
| Power Source | Corded |
