14
A
VENTILATION
To maximize comfort including ventila-
tion of SHARK Micro, R&D has produced
a new concept combining creating air
channels in the damping elements and
insertion of broadcasters in the cap
thermo compressed.
The air fl ow is optimal cooling and
allows a real skull. Air enters through the
upper front ventilation (Fig. A), circulates
and cools the head through the diffusers
integrated in internal damping elements.
The quality and design of textile comfort
participate in the dissemination of good
air. The position of the upper ventilation
is determined to maximize the effecti-
veness of its air intake. Depending on
your machine, the fairing can reduce the
effectiveness of the ventilation.
WARRANTY
5 years Warranty
You have recently purchased a SHARK helmet for your
safety and pleasure. It has been designed with the grea-
test care to satisfy your every requirement. For your sa-
fety, and that of your passenger, you must respect all the
rules of prudence when using your two-wheeled vehicle.
The SHARK 5-YEAR warranty guarantees the initial pur-
chaser that any possible manufacturing fault or material
defect will be covered by the SHARK warranty.
Limitations
If during the warranty period (5 years as from the date
of purchase), a problem covered by the warranty were
to arise, SHARK, through the intermediary of its sales
network, undertakes to repair or replace any defective
components, up to a maximum limit which is the pur-
chase value of the helmet. Any labour costs are normally
paid by the SHARK network, but are submitted for appro-
val prior to the work being carried out.
If the repair requires components to be dispatched incur-
ring transportation costs, the SHARK network shall cover
these costs up to a limit which is the cost of transport by
the national postal service at the normal rate.
Exclusions
This warranty only covers problems related to materials
or manufacturing. SHARK cannot be held liable with
regard to the product in the following cases :
Any damage following
1) a fall or accident
2) a technical modifi cation made by the user or a third
party (glue, adhesives, paint, screws, etc.)
3) use of or contact with: harmful chemical products
(including methylated spirits on the visor treatments), or
an intense heat source
4) incorrect use: abnormal conditions (e.g. underwater),
lack of maintenance or care
5) ageing due to normal wear of the inner fabrics or
foams, the appearance of the external parts, or the visor
(scratches, marks, etc.)
6) abnormal and prolonged exposure to ultra- violet
light, in particular for the decorative colours. In addition,
SHARK cannot consider subjective considerations related
to use of the helmet as defects covered by the warranty:
problems with comfort, size, noise or whistling, aerody-
To Next Page
Loading...
Need help?
General
