Shark Nano User Manual

A
C
B
D
TEXTILE PARTS
TEXTILE PARTS
DISMANTLING THE INTERIOR.
- Turn your helmet over.
- Separate the two parts of the chin strap
- Take off the strap from its passer (fig. A).
- Unhook the velcro of the two cheek pads
(Fig. B) and slide them along the chin straps
to extract them.
- Remove the neck pad by holding one of its
sides. Pull out the end and then detach its
rear section (Fig. C).
- To complete the operation, unclip the front
of the head section, starting with one side
(Fig. D) and remove the head section.
WARNING! The interior padding is
critical to maintain the correct fit of
the helmet on your head. If you have any
doubt whatsoever regarding the removal or
replacement of the interior padding, DO NOT
USE YOUR HELMET. Contact your retailer
for assistance or advice. NEVER use your
helmet with any part of the interior padding
removed. The helmet will not protect you in
an accident.
REPLACING THE INTERIOR.
- Start the operation by sliding the plastic tabs
of the front of the head section in its housing
beginning with one side (Fig. A).
- Insert one end of the neck pad at the edge of
the helmet, and feed the remainder of the neck
pad beneath the edge of the helmet. Insert the
other edge of the neck pad at the other edge of
the helmet (Fig. B).
- Re-Engage the strap in its passers (fig. C).
- Then, hook the Velcro bands (Fig. D).
14

Shark Nano Specifications

General

Brand	Shark
Model	Nano
Category	Motorcycle Accessories
Language	English