PUTTING ON THE HELMET
Once the chin strap is released, you
have to take hold of the two sections
by the buckles and hold them slightly
apart to facilitate the passage of your
head. While carrying out this move-
ment, you are advised to keep the two
sections of the chin strap apart with
your thumbs so that they are properly
positioned.
Position the protective parts of the
chin strap buckle correctly and fasten
it in accordance with the recommen-
dations that are appropriate to the
versions and country.
Check that the tension and therefore
the positioning of the helmet are cor-
rect for all positions. If this is not the
case, you must continue to adjust
the length until you achieve the ideal
positioning.
REMOVING THE HELMET
Release the chin strap. Hold the two
sections slightly apart as for putting
the helmet on and remove the helmet.
WARNING! If you cannot
properly fasten your chin strap
or obtain the correct fit of your hel-
met on your head, DO NOT USE THE
HELMET! See your retailer for assis-
tance.
ADVICE FOR USE
CHIN STRAP MICROMETRIC BUCKLE
HOLDING SYSTEM
Depending on the various versions and the
country concerned, your SHARK Nano helmet
is equipped with a chin strap with a “Precise
Lock” rapid buckle with a snap lock.
The “Precise Lock” snap lock system gives you
precise and accurate adjustment because of
the considerable length of its notched section.
However, it is essential on purchase to adapt the
length of the chin strap to your measurements.
Adjust the length of the strap using the adjusting
buckle (Figs. A, B, C and D).
8
To Next Page
Loading...
Need help?
General
