Shark NAVIGATOR LIFT-AWAY NV391 User Manual

ASSEMB LY
WHAT’S INSIDE MAINTENANCE
QUICK START GUIDE
NAVIGATOR
™
LIFT-AWAY ®
Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
Press top dust
cup release latch
to access dust
screen and remove
built-up debris
asrequired.
Pre-Motor (foam and felt):
With the dust cup removed, take out the foam and felt filters
and rinse them with water. Tap loose dirt o filters between
washes as needed.
Post-Motor (HEPA):
To access the HEPA filter, reach under the grill, pull the tab
forward and pull the grill away from the vacuum. Remove
and rinse the HEPA filter.
Empty dust cup after each use
TIP:
Wash filters every
3 months to keep
the suction strong.
Rinse filters and allow
to air-dry completely.
Tap loose dirt from
foam filters as needed
between washes.
Easy brushroll maintenance
Cleaning Filters
To remove the
dust cup, undo
the latches on the
sides by lifting
them up and
outwards.
Use a coin to open the 2
locks on the bottom of the
floornozzle.
Hold dust cup
over a trash bin
and press the
empty-release
latch on the
bottom.
Remove any string, carpet
fibers, or hair that may
be wrapped around the
brushroll.
A
Handle
B
Motorized Floor Nozzle
C
Wand
D
Crevice Tool
E
Wide Upholstery Tool
F
Dusting Brush
G
Pet Power Brush
H
Multi-Angle Dusting Brush
Foam filter
Felt filter
HEPA filter
Place the pod
onto floornozzle.
Slide accessory
holder onto
extension wand.
Insert handle into top of
wand, then attach hose
connector on back of pod.
Slide wand into
base ofpod.
1
(Click)
2
(Click)
4
(Click)
3
(Click)
A
B
C

Shark NAVIGATOR LIFT-AWAY NV391 Specifications

General

Type	Upright
Model	NV391
Cord Length	25 ft
Filtration	HEPA
Technology	Lift-Away
Warranty	5 years
Filtration Type	HEPA
Accessories	Crevice Tool, Dusting Brush

Summary

Shark Navigator Lift-Away Assembly

Attach Pod to Floor Nozzle

Connect the vacuum pod onto the floor nozzle by aligning and clicking it into place.

Insert Wand into Pod Base

Slide the wand into the base of the vacuum pod to connect them securely.

Attach Accessory Holder to Wand

Slide the accessory holder onto the extension wand for convenient storage.

Connect Handle and Hose

Insert the handle into the wand and connect the hose to the back of the pod.

Shark Navigator Lift-Away Maintenance

Emptying the Dust Cup

Learn how to remove, empty, and clean the dust cup for optimal suction.

Cleaning Vacuum Filters

Instructions on washing foam, felt, and HEPA filters every 3 months for strong suction.

Brushroll Maintenance

Tips for cleaning string, hair, and fibers wrapped around the brushroll.

Using Vacuum in Lift-Away Mode

Lift Pod Off Floor Nozzle

Release the pod from the floor nozzle to begin using Lift-Away mode.

Use for Short Reach Cleaning

Press the handle release button for cleaning in tight or short-reach areas.

Use for Longer Reach Cleaning

Press the extension wand release button for extended reach cleaning.

Attach Cleaning Tools

Connect the appropriate cleaning tool to the handle or wand for specific tasks.