Shark NV181 - Checking for Blockages; Cleaning the Brushroll; Cord Maintenance

sharkclean.comsharkclean.com
Clean o any debris on the bristles.
Using a coin, turn locks counterclockwise, then lift the cover to access brushroll.
If you run
over a hard
or sharp
object or
notice a noise
change while
vacuuming,
check for
blockages
or objects
caught behind
the brushroll.
Clear away
any dust, dirt,
or blockages in Debris Intake.
To close the cover, push down until it clicks into
place. Close the locks by using a coin to turn
them clockwise.
DEBRIS WRAPPED AROUND BRUSHROLL
DEBRIS BEHIND BRUSHROLL
CLEANING THE BRUSHROLL
MAINTENANCE
CHECKING FOR BLOCKAGES
Detach hose from vacuum pod,
and check hose and opening on
back of pod for blockages.
Detach wand from pod and handle,
and check both ends for blockages.
Detach wand from pod, and
check opening for blockages.
Detach handle from wand and
hose from the vacuum pod, and
check openings for blockages.
Detach dust cup from vacuum
pod. Empty dust cup, remove
debris from lint screen, and check
for blockages.
HOSE BLOCKAGES WAND BLOCKAGES
POD BLOCKAGES HANDLE/HOSE BLOCKAGES
DUST CUP BLOCKAGES
To minimize the risk of power cord damage, DO
NOT run the vacuum over the power cord. If this
occurs, immediately shut o power to the vacuum
and remove the cord from the brushroll or nozzle.
1. DO NOT pull or carry vacuum cleaner by
the cord or use cord as a handle.
2. DO NOT unplug by pulling on the cord.
Grasp the plug, not the cord.
3. DO NOT close the door on the cord.
4. DO NOT pull the cord around sharp
corners.
5. DO NOT leave the cord near heated
surfaces.
CORD MAINTENANCE