sharkclean.comsharkclean.com
ASSEMBLY SETTINGS
CLEANING MODES
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please use setting II, Carpet.
NOTE: Select Carpet for stuck-on dust and debris.
NOTE: All accessories are compatible with both the wand and the handheld vacuum.
Slide switch to the bottom
to turn o power. To begin
vacuuming, slide switch to
the appropriate setting.
Bare Floor/Small Area Rugs
The brushrolls spin slowly
to clean bare floors and
small arearugs.
Carpet
The brushrolls spin faster
to pick up debris below
the surface ofyour carpets.
OFF SETTING I SETTING II
To clean floors, place foot on floor nozzle
and tilt handheld vacuum back.
UPRIGHT
Detach the wand for more reach to clean
baseboards, ceiling fans, window sills, and other
hard-to-access areas. Stand the vacuum upright,
then step on the foot pedal on the left side of the
floor nozzle and pull the wand up to disconnect it.
ABOVE-FLOOR WITH WAND
Press the Wand Release button to lift the handheld
vacuum o the wand. Great for cleaning stairs and
furniture.
Wand Release
Button
ABOVE-FLOOR HANDHELD
(Click)
(Click)
1 2
1. Insert Wand into Floor Nozzle.
Ensure all connections click securely into place.
2. Insert Handheld Vacuum into the Wand.
To Next Page
Loading...
Need help?
General
