sharkclean.comsharkclean.com
1. Using a coin, turn locks counterclockwise to
open, then lift o cover to access Brushroll.
2. Clear airway of blockages.
3. Replace cover, pressing down firmly on all sides
before turning locks clockwise to close.
CLEANER HEAD MAINTENANCE
MAINTENANCE
CHECKING FOR BLOCKAGES
MAINTENANCE
Remove the wand from the
handheld vacuum and check
all dust cup intake openings.
Detach the wand, then use
the edge of a coin to open the
three locks on the bottom of
the cleaner head. Remove the
cover, then tilt back the neck of
the cleaner head and check the
opening for blockages. Replace
cover, pressing down firmly on
all sides before turning locks
clockwise to close.
ZERO-M™ TECHNOLOGY
Zero-M Technology™ actively removes hair wrap from your brushroll while you vacuum. If you run over a
hard or sharp object or notice a noise change while vacuuming, check for blockages or objects caught in
the brushroll.
Detach the wand and check it
for blockages.
NOTE: If any hair is wrapped around the brushroll, extending cleaning time will allow Zero-M™ technology to remove it
for you. If some fibers remain wrapped around the brushroll after continued use, carefully cut debris with scissors and
remove from brushroll.
CHECK HANDHELD
CHECK CLEANER HEAD
CHECK WAND
TECHNOLOGY
WITH
™
To Next Page
Loading...
