sharkclean.comsharkclean.com
ASSEMBLY SETTINGS
CLEANING MODES
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please use setting II, Carpet.
NOTE: Select Carpet for stuck-on dust and debris.
NOTE: All accessories are compatible with both the wand and the handheld vacuum.
Slide switch to the
bottom to turn o power.
To begin vacuuming,
slide switch to the
appropriate setting.
Bare Floor/Small Area
Rugs
The brushroll spins slowly
to clean bare floors and
small arearugs.
Carpet
The brushroll spins
faster to pick up debris
below the surface
ofyour carpets.
OFF SETTING I SETTING II
To clean floors, step on floor nozzle
and tilt handheld vacuum back.
UPRIGHT
Detach the wand for more reach to clean
baseboards, ceiling fans, window sills,
and other hard-to-access areas. Stand the
vacuum upright, then step on the foot pedal
on the side of the floor nozzle and pull the
wand up to detach it.
ABOVE-FLOOR WITH WAND
Press the WAND RELEASE button to
lift the handheld vacuum o the wand.
Great for cleaning stairs and furniture.
ABOVE-FLOOR HANDHELD
WAND
(Click)
1 2
1. Insert Wand into Floor Nozzle. 2. Insert Handheld Vacuum into wand.
Ensure all connections click securely into place.
(Click)
3
4
3. Remove Odor Neutralizer Technology
Dial from bag. Flip up the dial handle, align
the teal arrows, then insert the dial into the
nozzle.
* More detailed Odor Neutralizer Technology assembly instructions and visuals on the
following two pages.
4. To lock and engage the dial, rotate it
counterclockwise until it clicks into the
desired odor intensity setting.
(Turn to
Click)
To Next Page
Loading...
Need help?
General
