Shark Rocket Pro HN175 Series

sharkclean.comsharkclean.com
Regularly clean and replace the filters to keep your vacuum's suction power optimal.
IMPORTANT: To prevent damage, rinse filters with water ONLY . DO NOT use soap. Allow filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electricparts.
MAINTENANCE
CLEANING FILTERS
IMPORTANT: Unplug the vacuum before performing any maintenance.
NOTE: The pre-motor filters should be
replaced every 2.5 years. The post-motor filter
should be replaced every 3 years.
PRE-MOTOR FILTERS POST-MOTOR FILTER
Replacement Pre-Motor Filter Kit
XPMFK320
Replacement Post-Motor Filter
1084FTV320
REPLACEMENT FILTERS
Open the lid on the top of the handheld
vacuum to lift out the pre-motor filters.
The Pre-Motor Filters should be washed
once a month.
To remove the post-motor filter, open the
filter cover on the handheld vacuum and pull
out the filter. The Post-Motor Filter should be
washed once every year.
MAINTENANCE
EMPTYING THE DUST CUP
Press the WAND RELEASE button and lift
the handheld vacuum o the wand.
With the dust cup attached to the handheld
vacuum, hold the handheld vacuum over the
trash, then press the Empty button on the
dust cup to release dirt and debris.
To remove the dust cup from the handheld
vacuum, squeeze the two Dust Cup Release
buttons at the same time and pull out the dust
cup. Hold the dust cup over the trash, then press
the Empty button to release dirt and debris.
Empty the dust cup each time you vacuum and periodically during cleaning, when debris in
the dust cup reaches the MAX fill line.
IMPORTANT: Unplug the vacuum before performing any maintenance.
OR
Empty
Dust Cup
Release
WAND