EasyManuals Logo

Shark Stratos DuoClean HZ3000UK Series User Manual

Shark Stratos DuoClean HZ3000UK Series
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
MAINTENANCE MAINTENANCE
NOTE: For replacement filters please visit sharkclean.co.uk
REPLACEMENT FILTERS
Regularly rinse and replace the filters to maintain your vacuum's suction power and to maximise the
eectiveness of the Anti-Odour Technology.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Do not use soap. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electronic parts.
CLEANING FILTERS
IMPORTANT: Unplug the vacuum before performing any maintenance.
PRE-MOTOR FILTERS
The Pre-Motor Filters should be rinsed every month. To remove
the pre-motor filters, detach the dust cup, then slide down the
Filter Access buttons on both sides of the dust cup lid. Pull out
the filter housing, then lift out the Felt Filter by the pull tab. Next,
remove the Foam Filter. After the filters have been rinsed and are
completely dry, insert the foam filter into the housing first, then
slide in the felt filter, and reinstall the housing into the dust cup lid.
The HEPA Filter should be rinsed every 6
months. To remove the HEPA filter, detach
the dust cup, then pull the Filter Release
tab on the handheld vacuum filter cover.
Remove the cover, then squeeze the side
tabs on the HEPA filter and lift it out. After
the filter has been rinsed and is completely
dry, reinsert it into the handheld vacuum,
then reattach the filter cover.
HEPA FILTER
NOTE: The pre-motor filters should be
replaced every 2.5 years. The post-
motor filter should be replaced every
3 years.
EMPTYING THE DUST CUP
Press the Wand Release button and lift o
the handheld vacuum.
To remove the dust cup from the handheld
vacuum, press the two Dust Cup Release
buttons at the same time and pull out the
dust cup from the top.
To reinstall, push the lid closed, then insert
the dust cup into the handheld vacuum from
the top, until it clicks into place.
Hold the dust cup over the bin. Press the yellow
Empty button and pull open the dust cup lid until
it clicks and locks in the open position. Gently tap
the cone-shaped screen inside the dust cup to
knock dust and debris into the bin.
Empty the dust cup each time you vacuum and periodically during cleaning, when debris in the dust cup
reaches the MAX fill line.
IMPORTANT: Unplug the vacuum before performing any maintenance.
(Click)
15sharkclean.co.uk14 sharkclean.co.uk

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Shark Stratos DuoClean HZ3000UK Series and is the answer not in the manual?

Shark Stratos DuoClean HZ3000UK Series Specifications

General IconGeneral
BrandShark
ModelStratos DuoClean HZ3000UK Series
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals