3
21KF-80S
ELECTRICAL SPECIFICATIONS
WARNING
The chassis in this receiver is partially hot. Use an isolation transformer between the line cord plug and
power receptacle, when servicing this chassis.
To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer servicing to
qualified service personnel.
Specifications are subject to change without prior notice.
•Power Input .................... 220V-240 Volts AC 50Hz
•Power Consumption
Normal Operation (Method IEC60107) ........ 49W
Stand-by Operation .................................. 3W
•Audio Power Output Rating .............. 4W x 2 (MPO)
•Speaker ......................... 16Ω 4W, 12 x 5 cm, 2pcs
•Convergence ................... Self Converging System
•Focus ............................... Bi-Potential Electrostatic
•Sweep Deflection ..................................... Magnetic
•Picture Intermediate Frequency .............. 38.9MHz
•Sound Carrier Trap .............................. 33.4MHz
•Adjacent Sound Carrier Trap ................ 40.4MHz
•Adjacent Picture Carrier Trap .............. 31.9MHz
•Aerial Input Impedance
VHF/UHF .................... 75 ohm Unbalanced
•Tuning Ranges ......... 48.25MHz thru 855.25 MHz
VHF ....................... CH02-CH12
S1-S41 (HYPERBAND)
UHF ....................................... CH21 - CH69
•White Level
Set the brightness control, with no signal connected, so that the CRT cathode current is 600µA. The maximum
correction applied to each cathode current to achieve a screen temperature of 8550 degrees K+1 MPCD should
not exceed 15% of its original value.
X=0.290 ± 0.015 Y=0.300 ± 0.015
To Next Page
Loading...
