Sharp 21V-FW100S - Page 25

21V-FW100S
5 – 14
ADJUSTMENT
ITEM
ADJUSTMENT
POSITION
CONTROL
PRE-ADJUST
REQUIREMENT
CONTENT
INPUT
CONDITION
OUTPUT
ADJUSTMENT
PROCEDURE
SYMBOL
MODEL NAME
SUB-TINT
V02
STEP RANGE
0-127
21V-FW100S
I2C CONT ROL
OPTION SET UP, BUS SET UP, VCO ADJ, RF-AGC
US 10 CH HALF COLOR BAR PATTERN
220 V
B-AMP TR BASE (JA410)
CONFIRRM WITH OSCILLOSCOPE
1) GET IN Y-MUTE FUNCTION BY R/C .
2) ADJUST THE
V02
BUS DATA TO GET A WAVEFORM AS BELOW.
[CONFIRMATION ]
HISTORY
OF REVISION
REVISED CONTENT .
B-AMP BASE (TP 47B)MUST BE IN
STEPPING LEVEL
3) DISABLE THE Y-MUTE
** PLS TAKE NOTE THAT SERVICE MODE DATA F62 NEED TO SET 0.