EasyManua.ls Logo

Sharp 32JW-74EES - Component Data and Servicing Information; ICs Additional Information

Sharp 32JW-74EES
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
51
32JW-74E
1 FEATURES
5 V supply voltage
Gain controlled wide-band Vision Intermediate
Frequency (VIF) amplifier, AC-coupled
Multistandard true synchronous demodulation with
active carrier regeneration: very linear demodulation,
good intermodulation figures, reduced harmonics, and
excellent pulse response
Gated phase detector for L and L-accent standard
Fully integrated VIF Voltage Controlled Oscillator
(VCO), alignment-free, frequencies switchable for all
negative and positive modulated standards via I
2
C-bus
Digital acquisition help, VIF frequencies of 33.4, 33.9,
38.0, 38.9, 45.75, and 58.75 MHz
4 MHz reference frequency input: signal from
Phase-Locked Loop (PLL) tuning system or operating
as crystal oscillator
VIF Automatic Gain Control (AGC) detector for gain
control, operating as peak sync detector for negative
modulated signals and as a peak white detector for
positive modulated signals
External AGC setting via pin OP1
Precise fully digital Automatic Frequency Control (AFC)
detector with 4-bit digital-to-analog converter, AFC bits
readable via I
2
C-bus
TakeOver Point (TOP) adjustable via I
2
C-bus or
alternatively with potentiometer
Fully integrated sound carrier trap for 4.5, 5.5, 6.0,
and 6.5 MHz, controlled by FM-PLL oscillator
Sound IF (SIF) input for single reference Quasi Split
Sound (QSS) mode, PLL controlled
SIF-AGC for gain controlled SIF amplifier, single
reference QSS mixer able to operate in high
performance single reference QSS mode and in
intercarrier mode, switchable via I
2
C-bus
AM demodulator without extra reference circuit
Alignment-free selective FM-PLL demodulator with high
linearity and low noise
I
2
C-bus control for all functions
I
2
C-bus transceiver with pin programmable Module
Address (MAD)
Four I
2
C-bus addresses via MAD.
2 GENERAL DESCRIPTION
The TDA9885 is an alignment-free multistandard
(PAL and NTSC) vision and sound IF signal PLL
demodulator for negative modulation only and
FM processing.
The TDA9886 is an alignment-free multistandard
(PAL, SECAM and NTSC) vision and sound IF signal PLL
demodulator for positive and negative modulation,
including sound AM and FM processing.
3 APPLICATIONS
TV, VTR, PC and STB applications.
4 ORDERING INFORMATION
TYPE NUMBER
PACKAGE
NAME DESCRIPTION VERSION
TDA9885T/V3 SO24 plastic small outline package; 24 leads; body width 7.5 mm SOT137-1
TDA9885TS/V3 SSOP24 plastic shrink small outline package; 24 leads; body width 5.3 mm SOT340-1
TDA9885HN/V3 HVQFN32 plastic, heatsink very thin quad flat package; no leads; 32 terminals;
body 5 × 5 × 0.85 mm
SOT617-1
TDA9886T/V3 SO24 plastic small outline package; 24 leads; body width 7.5 mm SOT137-1
TDA9886TS/V3 SSOP24 plastic shrink small outline package; 24 leads; body width 5.3 mm SOT340-1
ICs ADDITIONAL INFORMATION
TDA9886TS (IC201)
Features

Related product manuals