EN-10
(For SMD models only)
Use when the blue PLASMACLUSTER
lamp on the unit is too bright. (The
red OPERATION lamp and the orange
TIMER lamp cannot be turned off.)
1
During operation, press the DIS-
PLAY button.
The blue PLASMACLUSTER lamp (
)
will turn off.
TO LIGHT UP
Press the DISPLAY button again.
DISPLAY BUTTON
1
SELF CLEAN operation will reduce
the growth of mold fungus with
Plasmacluster ions and dry inside of the
unit. Utilize the operation at seasonal
change over terms or every 4 months
.
1
Press the SELF CLEAN button when
the unit is not operating.
The remote control will display .
The blue PLASMACLUSTER lamp ( )
will light up.
The unit will stop operation after 40
minutes.
TO CANCEL
Press the SELF CLEAN button.
The blue PLASMACLUSTER lamp ( )
will turn off.
NOTE:
You cannot set the temperature, fan speed, air
CLEAN operation.
Mold fungus already grown can not be eliminated
by this operation.
SELF CLEAN OPERATION
1
(For SMD models only)
AH-AP9SMD&ED_OM_A908_En.indd 102015/3/24 16:54:19
To Next Page
Loading...
Need help?
General
