EasyManua.ls Logo

Sharp AQUOS LC-29LE440M - Setting the TV; Connecting the Antenna Cable; Attaching the TV Stand

Sharp AQUOS LC-29LE440M
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
Setting the TV
Connecting the antenna cable
To enjoy a clearer picture, use an outdoor antenna.
or
VHF/UHF
antenna
300-ohm twin-
lead at feeder
(not supplied)
75-ohm
impedance
converter
(not supplied)
Antenna adaptor
(supplied for Philippine only)
75-ohm coaxial
cable (round cable)
(not supplied)
To antenna terminal
For Philippine model only
If your outdoor antenna uses a 75-ohm coaxial cable with
a standard DIN45325 plug (IEC 169-2), plug it into the
antenna jack at the rear of the set.
If your outdoor antenna uses a 75-ohm coaxial cable with F
type plug, plug it into the antenna jack at the rear of the set.
CAUTION
TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
AC CORD CONNECTED.
The illustrations used throughout this manual are based on LC-39LE440M.
NOTE
The method of connection differs depending on a type of wires for aerials that you use. Attach an optional conversion plug (for
the Philippines) compatible with the type of wires for arials that you use to the installation device. Make sure to power off the
device for safety when you connect to a wire for aerials.
Attaching the stand
Before attaching (or detaching) the stand, unplug the AC cord from the AC outlet.
Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
1
Con rm the screws supplied with the TV.
LC-29LE440M Screw (4
m
16 mm):
m
4, (4
m
10 mm):
m
1
LC-39LE440M Screw (4
m
10 mm):
m
4, (4
m
25 mm):
m
3
2
Attach the stand base, insert and tighten the screws into the holes on the bottom of the stand base.
NOTE
To detach the stand, perform the steps in reverse order.
LC-29LE440M
4x16 mm
4x10 mm
LC-39LE440M
4x25 mm
4x10 mm
If your outdoor antenna uses a 300-ohm twin-lead at
feeder (F type), connect a 300-ohm to 75-ohm impedance
converter and plug it into the antenna jack at the rear of the
set. If you use M type plug, plug it into the antenna jack at
the rear of the set directly.
VHF/UHF
antenna
J3PI2101B_EN.indd 3J3PI2101B_EN.indd 3 5/27/2013 1:57:15 PM5/27/2013 1:57:15 PM

Related product manuals