Basic adjustment settings
Power control setting allows you to save energy.
No signal off
When set to "Enable", the power will automatically shut
down if there is no signal for 15 minutes.
Press MENU to display the MENU screen, and
then press _ll/l_ to select "Power Control".
Press A/Y to select "No Signal Off", and then
press ENTER.
Press _ll/ll_ to select "Enable", and then press
ENTER.
,, Five minutes before the power shuts down, the
remaining time displays every minute.
Press MENU to exit.
This setting allows you to optimize the settings of
Digital broadcasting.
You can output digital audio to an AV amplifier or
similar device whose DIGITAL AUDIO INPUT terminal
is connected to the DIGITAL AUDIO OUTPUT terminal
on the TV. Please select an audio output format
compatible with the audio format of the program you
are watching and the equipment connected.
Press MENU to display the MENU screen, and
then press _/l_ to select "Digital Setup".
Press A/Y to select "Audio Setup", and then
press ENTER,
Press A/Y to select "PCM" or "Dolby Digital",
and then press ENTER.
o "Disable" is the factory preset value.
,, When a TV program finishes, this function may not operate.
No operation off
When set to "Enable", the power will automatically shut
down if there is no operation for 3 hours.
Press MENU to display the MENU screen, and
then press _ll/l_- to select "Power Control".
Press A/Y to select "No Operation Off", and
then press ENTER.
Press _l/l_- to select "Enable", and then press
ENTER.
,, Fiveminutesbefore the powershuts down, the
remainingtime displaysevery minute.
Press MENU to exit.
PCM The optical output terminal outputs audio
signalin PCMform. Ifyour digital audio
systemdoes not support Dolby Digital,
select"PCM".
Dolby Digital The optical output terminal outputs audio
signalin Dolby Digitalform. It reproduces
soundfrom surround program of digital.
Press MENU to exit.
,, "Disable" is the factory preset value.
Q- 28
To Next Page
Loading...
