Sharp AQUOS LC-40LE822E

23
SCART connection
Example of connectable devices
VCR
DVD player/recorder
E
E
q
r
VCR Decoder
SCART cable (supplied accessory)/Conversion
cable
SCART cable


NOTE
In cases when the decoder needs to receive a signal from
the TV, make sure to select the EXT 1 terminal to which the
decoder is connected in “Manual adjust” in the “Analogue
setting” menu (Page 34).
You cannot connect the VCR with decoder using a fully wired
SCART cable when selecting “Y/C” under “EXT 1” in the “Input
select” menu.
•
•
YPB
(
CB)
PR
(
CR)
Component connection
Example of connectable devices
VCR
DVD player/recorder
E
E
You will enjoy accurate colour reproduction and high
quality images through the EXT 3 terminal when
connecting a DVD player/recorder or other device.
LR
AUDIO
YPB
(CB)
P
R
(CR)
(G) (B) (R)
COMPONENT
s
t
Stereo conversion
cable*
 RGB component
cable (supplied
accessory)/
Conversion cable

The supplied conversion cable (AV cable) is only used for
the EXT 2 terminal, not for the Audio IN/OUT terminal. Use a
stereo conversion cable (commercially available) instead.
*
After connecting
You must select the appropriate input source and
input signal settings for component connection to
enjoy high quality image through the EXT 3 terminal.
Selecting the component signal
Press b to select “EXT 3” from the
“INPUT” menu, and then press ;.
Go to “Menu” > “Setup” > “Option” >
“Terminal setting” > “Input select” >
select “COMPONENT”.
Setting audio output
Go to “Menu” > “Setup” > “Option” >
“Terminal setting” > “PC input” > “Audio
select” > select “Video+Audio”.
E
1
2
Connecting external devices
LC-LE822ERU_GB.indd 23LC-LE822ERU_GB.indd 23 2010/08/25 11:21:582010/08/25 11:21:58