Sharp AQUOS LC-42D64U

Using external equipment
Press MENU to exit.
Press
...... /~ to select "Yes", and then press
ENTER.
Press
J../T to select "Input Skip", and then
press ENTER.
Press
J../T to select the Input (INPUT 4,
INPUT 5, INPUT 6 or INPUT 7) you wish to
skip, and then press ENTER.
This setting allows you to skip the
HOMI or PC-IN Input
on the Input Selection operation.
Press
MENU to display the MENU screen, and
then press
...... /~ to select "Setup".
Press
J../T to select the desired item, and
then press ENTER.
Press
...... /~ to select the desired setting, and
then press ENTER.
Press
MENU to display the MENU screen, and
then press
...... /~ to select "Option".
Press
J../T to select "HOMI Setup", and then
press ENTER.
To watch
an HOMI or PC-IN equipment image,
select "INPUT4", "INPUTS" or "INPUT 6" from
"INPUT SOURCE" menu using
INPUT on the
remote control unit or on the
TV.
Auto View Enable
Disable
Set whether or not to use
View Mode based on signal
recognition, including
an HDMI
signal.
Audio
Select
Digital
Analog
Select "Digital" for
an audio
signal via the HDMI terminal.
Select "Analog" for
an audio
signal via the R-AUDIO -L
terminal.
Press MENU to exit.
• Refer to your external equipment operation manual for the
signal type.
• "Audio Select"
is only available for INPUT 6.
• When connecting an HDMI-DVI conversion adapter/cable
to the HDMI terminal, the image may not come
in clearly.
(@- 31
Using external equipment
Press MENU to exit.
Press
...... /~ to select "Yes", and then press
ENTER.
Press
J../T to select "Input Skip", and then
press ENTER.
Press
J../T to select the Input (INPUT 4,
INPUT 5, INPUT 6 or INPUT 7) you wish to
skip, and then press ENTER.
This setting allows you to skip the
HOMI or PC-IN Input
on the Input Selection operation.
Press
MENU to display the MENU screen, and
then press
...... /~ to select "Setup".
Press
J../T to select the desired item, and
then press ENTER.
Press
...... /~ to select the desired setting, and
then press ENTER.
Press
MENU to display the MENU screen, and
then press
...... /~ to select "Option".
Press
J../T to select "HOMI Setup", and then
press ENTER.
To watch
an HOMI or PC-IN equipment image,
select "INPUT4", "INPUTS" or "INPUT 6" from
"INPUT SOURCE" menu using
INPUT on the
remote control unit or on the
TV.
Auto View Enable
Disable
Set whether or not to use
View Mode based on signal
recognition, including
an HDMI
signal.
Audio
Select
Digital
Analog
Select "Digital" for
an audio
signal via the HDMI terminal.
Select "Analog" for
an audio
signal via the R-AUDIO -L
terminal.
Press MENU to exit.
• Refer to your external equipment operation manual for the
signal type.
• "Audio Select"
is only available for INPUT 6.
• When connecting an HDMI-DVI conversion adapter/cable
to the HDMI terminal, the image may not come
in clearly.
(@- 31