7
Protection against overturning
There is a danger of the product overturning in the case of a disaster or sudden collision. Carry out the following tip-
resistant measurement for your safety.
Anchoring the TV to the wall or a pillar
1 Affix the TV to the wall or a pillar using
extra strong ties and cup hooks.
View from the top
no
Wall
Cup hook (commercially available)
Tie (commercially available)
Fixing the TV to the table
1 Place the TV on the table.
2 Pull the attached restraining bracket out so that it
is at a 90 degrees angle.
3 Insert commercially available screw in the hole of
the restraining bracket and tighten the screw to
secure the TV to the table.
• Use commercially available screw to firmly secure the TV.
CAUTION
• As this product is heavy, use a table that is wide
enough to support the product and capable of
withstanding the product’s weight. The table should be
set where it will not be overturned.
• Be sure to use at least two people when moving the TV.
Stand
Restraining bracket
Screw
(commercially
available)
Preparation
LC60LE640X_EN_book.indb 7LC60LE640X_EN_book.indb 7 9/10/2012 2:48:15 PM9/10/2012 2:48:15 PM
To Next Page
Loading...
