UsingtheInternet
AQUOS
NET APPS
This function can be used to display up-to-date
information on the original home page and allow you to
receive support service over the network.
| If you cannot connect to the Internet
Perform the procedures below to check your TV's
network settings.
1 Press EXIT to exit from the connected TV feature.
2 Press MENU to display the MENU screen, and then
press 4/_ to select "Initial Setup".
3 Press A/V to select "lntemet Setup", and then
press ENTER.
4 Press A/T to select "Network Setup", and then
press ENTER.
5 Press A/T to select "IP Setup", and then press
ENTER.
o Check that numbers are displayedfor each setting.
o Ifthere are any settings without numbers, specifythe
numbersby followingthe on-screen instructions.
o Forinformationon how to enter text, see page64.
Example
1 Press AQUOS NET once or twice.
o You can alsodisplaythe original homepage by
pressing FAYAPP on the remote control unit. See
page35 for detailson the FAVAPP key Assign
function.
o Eachtime you pressAQUOS NET, the screenimage
togglesas shown below:
TV+Web,_, Web,_, TV
t !
o Whenyou arenot connected to the Intemet,a network
functionexplanationscreen is displayed.
Theservicesdisplayed varydepending on
circumstances.
2 Press A/T/_U_ to select a title, and then press
ENTER.
• Theservicedetailsvary depending on circumstances.
3 Press EXIT to exit from the connected TV feature.
Web page appearances may differ depending on the type
of screen (TV+Web or Web).
o When displaying TV+Web with a channel in which the
V-Chip is enabled, the cursor keys on the remote control
unit do not function.
6 Press MENU to exit.
1 Repeat steps 1 to 4 in IP Setup.
2 Press A/T to select "Country", and then press
ENTER.
3 Press A/V to select "US", "Canada", "Mexico" or
"Others", and then press ENTER.
• Ifyou select "Others",you needto set the desiredarea.
4 Press MENU to exit.
1 Repeat steps 1 to 4 in IP Setup.
2 Press A/T to select "Zip Code", and then press
ENTER. After "Change" is highlighted, press
ENTER again.
3 Enter your zip code.
o Use0-9 on the remotecontrol unit, or usethe software
keyboard.
4 After "Complete" is highlighted, press ENTER.
5 Press MENU to exit.
1 Press APPS to display the application window.
2 Press 4/_- to select "AQUOS ADVANTAGE LIVE",
and then press ENTER.
You can alsodisplaythe AQUOSADVANTAGELIVE
screenby pressingFAVAPP on the remote control
unit. See page35 for details onthe FAVAPP Key
Assignfunction.
3 Press A/T/4/_- to select the desired service.
4 Press EXIT to exit from the connected TV feature.
o The display may change as a result of a software update.
Q- 63
To Next Page
Loading...
