QUICK REFERENCE
* Before attaching (or detaching) the stand, unplug the AC cord.
* Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
* Attach the stand in the correct direction.
* Do not remove the stand from the TV unless using a walJ mount bracket to mount it.
* Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falJing over.
* After attaching the stand to the TV, do not hold the stand when you put up, set up, move or lay down the TV.
Before attaching the stand to the TV, build a work 4
table on which to rest the TV.
* To build the table, use the cushioning materials used in the
packaging.
TOP-L '_ _J
TOP-R
_'_'-,¢'_,_ " TOP-C
* Of the cushioning materials used, TOP-C is also used
during stand unit assembly. Be sure to assemble the stand
unit before building the work table.
II Stand Unit Assembly
1 Confirm that there are 12 screws (8 long screws
and 4 short screws) supplied with the stand unit.
2 _ Set the post for thestand unit onto the TOP-C.
(20Attach the baseto the post.
(30Insertand tighten the 8 screws into the 8 holes
on the bottom of the base.
* Hold the stand unit securely with one hand, and then
tighten the screws.
®
_t _ _ Long
......
................................i!
II Building the Work Table
3
Insert each of the cushioning materials in the
respective directions shown in the figure.
,, Insert TOP-L and TOP-R into the left and right sides of
the case respectively.
,, Insert TOP-C to fit between the lines on the other side
of the case.
The case is equipped with push-in tabs to hold
the cushioning materials in place. Push in the
tabs (2 for each location) to secure the cushioning
materials in the case.
Pushdn tabs
After you have built the work table, spread a
blanket or similar soft cloth over the table and then
lay the TV display down on the covered table.
,, Do not usea small table for this.
II Attaching the Stand to the TV
6
Insert the stand into the openings on the bottom of
the TV.
,, Make sure that the stand is firmlyinserted intothe TV.
Improperinstallationmay result intiltingof the TVset.
7 Insert and tighten the 4 screws into the 4 holes on
the rear of the TV.
Short _ I_ \', ",__:_f_ _ _t_t
......
* To detach the stand, perform the steps in reverse order.
,, In the installation procedure, be careful not to catch your
fingers between the TV set and the floor.
Q-8
TOP-L
,CASE
_4 LINE
mx
To Next Page
Loading...
