EJ IMPORTANT INFORMATION
EJ
IMPORTANT SAFETY INSTRUCTIONS
Bl
uet o
oth
Notes
on
Radio
Wave
C
ert
ific
a
tion
in
the
U.SA.
and Canada
This device complies with part
15
of
the
FCC Rules. Operation
is
subject
to
the
follow
in
g
two
conditions:
(1) This device may not cause
harmful interference, and (2)
this
device must accept any interference
received,
including interference that may cause undesired operation.
"This transmitter
must
not
be
co-located
or
operated
in
conjunction with any
ot
her antenna
or
transmitter"
FCC/INDUSTRY CANADA NOTI
CE
This device
comp
lies with Part
15
of
FCC Rules and Industry Canada
li
cense-exempt RSS standard(s).
Operation
is
subject
to
the following
two
conditions: (1) this device
may
not
ca
u
se
interference, and
(2) this device
must
accept any interference, including interference that may cause undesired
operati
on
of
this
device.
Th
is equipment complies wi
th
FCC/IC radiation exposure limits
set
forth
for
an
uncontrolled
environment and meets
the
FCC radio frequency (RF) Exposure Guide
li
nes in Supplement C
to
OET65
and
RSS-1
02
of
the IC radio frequency
(R
F) Exprosure rules. This equipment has very low levels
of
RF
ener
gy
that
are deemed
to
comply without testing
of
specific absorption ratio (SAR).
FCC CAUTION
Changes
or
modificati
ons
not expressly approved
by
Hosiden responsible
for
compliance
cou
ld
void the
user's authority
to
operate the equipment.
Note: This equipment has been tested and found
to
comply with
the
limits
for
a Class B digi
ta
l device,
pursuant
to
Part 15
of
the FCC Rules. These
li
mi
ts
are designed
to
provi
de
reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can
radiate radio
frequency energy and,
if
not installed and used in accordance with
the
instructions, may cause harmful
interference
to
radio communications. However, there is no guarantee that interference will not
occur
in
a
particular installation.
If
this
equipment does cause harmful interference
to
radio
or
te
levision
reception,
wh
ich can be determined
by
turning
the
equipment
off
and
on
, the user is encouraged
to
try
to
correct
the
interference
by
one
or
more
of
the following measures:
Reorient
or
relocate the receiving antenna.
Increase the separation between
the
equipment and receiver.
Connect
the
equipment into an outl
et
on
a circuit different from that
to
which
the
receiver
is
connected.
Consult
the
dealer
or
an experienced radio/TV technician
for
help.
This Class B digital apparatus complies with Canadian ICES-003
Le present appareil
est
conforme aux Ia prtie
15
des
regles de Ia FCC et
CNR
d'lndustrie
Ca
nada appli
cat
aux appareils radio exempts de licence. L'exploitation
est
autorisee
aux
deux conditions suivant
es
:
(1)
l'appareil ne doit pas produire de brouillage,
et
(2)
ruitilisateur de l'appareil doit accepter tout
brouillage radioelectrique subi, meme si
le
brouillage
est
susceptible d'en compromettre le fonctionnement.
Cet
equipement
est
conforme aux limites d'exposition aux rayonnements enoncees pour un environnemen
non
contr61e
et
respecte l
es
regles les radioelectriques
(R
F)
de
Ia F
CC
lignes directrices d'exposition
clans le Supplement C
a OET65
et
d'exposition aux frequences radioelectriques (RF) CNR-102
de
I'
IC.
Cet
equipement erne! une energie
RF
tres faible qui
est
consideree conforme sans evaluation du debit
d'absorption specifique (DAS).
Cet
appareil numerique
de
Ia classe B
est
conforme a Ia norme NMB-3 du Canada.
ENG lmportant6
ENGLISH I FRAN<;AIS I ESPANOL
To Next Page
Loading...
