Sharp Aquos LC-80UE30U

EJ How to select the TV Mode EJ
Devices
Full screen view
Switching between connected devices is possible on the Devices full
screen.
1. Press .A./ T / <1111 /..,.to select the input source, and then press e
(ENTER).
2. Press .A./ T to select the "Switch to Device", and the press e
(ENTER).
• An image from the selected source automatically displays .
•
If the target input is not connected . you will be able to switch to the
input. but the correct video and audio will not be output. Be sure to
connect the equipment beforehand .
•
To display the Devices in the full screen or as a peek screen , .~~-~
P2.9.~ .. ~~! :
• Changing from a full screen view to another mode is possible .
Peek
screen view
The most commonly used input devices can be shown on the Dev ices
It is possible to configure which input devices to display on the peek
screen .
Six
devices are set by default.
To add a different de vice, first delete a current device , and then add the
device .
1 Select the device in Devices full screen and open the Devices menu .
2 Set "Show in Peek " to "Yes".
ENG 2-9
ENGLISH I FRAN<;AIS I ESPANOL