Sharp Aquos LC-80UE30U

EJ How to select the TV Mode EJ
Using the Touchpad Remote Control Unit (For UH30U model)
Preparation
Before using the Touchpad Remote Control Unit , you ha ve to follow the procedure shown below
to pair the unit with the TV.
1 Select " HOME"> "Settings · > "Remote & accessories · > " Add accessory ·.
2 Press the fili1 (HOME) and = (Back) buttons on the Touchpad Remote Control Unit at the
same time for 5 seconds .
About 20 seconds later , "SHARP Remote control device " is shown on TV screen .
3 Select "SHARP Remote control device · on TV screen . and then press e (ENTER) on the IR
Remote Control.
About 5-10 seconds later . PAIRED is shown . Preparation is complete.
• In preparation 3. if COULDN'T PAIR is shown , please try " preparation 1-3 " again .
• Pairing
success/failure may be influenced by the surrounding wireless / RF environment.
Mouse/Flick mode switch button
Switch the touch pad between Mouse mode and Flick mode.
• The default is Flick mode.
• Some apps may not function in Mouse mode . If an app does not function . switch to Flick mode .
. :
Display the Channels/Discover /Devices/TV Setup screen.
Slide bar
You can slide to display the Channels/Discover /Devices/TV Setup screen.
ENG 2-2
•
Slide from the left edge to the center to display the
Devices or TV Setup peek screen .
•
Slide from the left edge to the right edge to display
the Devices or TV Setup full screen .
•
Slide from the right edge to the center to display the
Channels or Discover peek sc r een.
• Slide from the right edge to the left edge to display
the Channels or Discover full screen.
ENGLISH I FRAN<;AIS I ESPANOL