Sharp AR-M355U - Page 161

AR-M351U/M451U, AR-M355U/M455U SIMULATION 9 - 25
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
* = MAINTENANCE
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
* = DV CARTRIDGE
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
* = COPY
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
After replacing the OPC drum, be sure to clear the OPC drum
counter.
24-4
Purpose Data clear
Function
(Purpose)
Used to reset the maintenance counter.
Item Counter
1 MAINTENANCE Maintenance counter
Press [START] key. Press [CUSTOM SETTINGS] key or [START] key.
24-5
Purpose Data clear
Function
(Purpose)
Used to reset the developer counter. (The
developer counter of the DV unit which is installed
is reset.)
Section Image process (Photoconductor/Developing/
Transfer/Cleaning)
Item Counter Developer
1 DV CARTRIDGE Developer cartridge
Press [START] key. Press [CUSTOM SETTINGS] key or [START] key.
SIMULATION 24-4
MAINTENANCE COUNTER DATA CLEAR. PRESS START.
1. MAINTENANCE
1
SIMULATION 24-4
* COUNTER DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
1
SIMULATION 24-5
DEVELOPER COUNTER DATA CLEAR. PRESS START.
1. DV CARTRIDGE
1
SIMULATION 24-5
* COUNTER DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
1
24-6
Purpose Data clear
Function
(Purpose)
Used to reset the copy counter.
Item Counter Copy
1 COPY Copy effective paper counter
Press [START] key. Press [CUSTOM SETTINGS] key or [START] key.
24-7
Purpose Data clear
Function
(Purpose)
Used to clear the OPC drum counter. (Perform this
simulation when the OPC drum is replaced.)
Section Image process (Photoconductor/Developing/
Transfer/Cleaning)
Item Counter Photo conductor
1 DRUM OPC drum counter
SIMULATION 24-6
COPY COUNTER DATA CLEAR. PRESS START.
1. COPY
1
SIMULATION 24-6
* COUNTER DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
1