Sharp AR-M450

AR-M350 MACHINE OPERATION 8-2
B. Adjustment values
(1) Adjustment values saved in PCU
Counters Adjustment values Others
Drum rotating time counter
(accumulated time)
Developing bias voltage value Serial number
Developing unit rotating time counter Cleaning mode developing bias voltage value Trouble history
Toner supply time (Section IC chip) Main high voltage adjustment Tray 1 size
Drum rotating time (Section IC chip) Transfer charger voltage value LCC tray size
Total counter Transfer belt cleaning voltage value Manual feed destination information
Maintenance counter Toner concentration reference value Tray 2 destination information
Developing counter Concentration correction start set time (Developing unit) Desk 1 destination information
Drum counter Concentration correction rotating time (Developing unit) Desk 2 destination information
Toner cartridge counter Concentration correction quantity (Developing unit) Machine tray remaining paper quantity data
Effective paper counter Correction execution direction, upper/lower limits
(Developing unit)
Multi-purpose remaining paper quantity data
Tray 1 paper feed counter Toner concentration temperature correction
(low temperature side) correction quantity
Option tray 1 remaining paper quantity data
Multi-purpose paper feed counter Toner concentration temperature correction
(low temperature side) set temperature
Option tray 2 remaining paper quantity data
Desk 1/LCC 1 paper feed counter Toner concentration temperature correction
(low temperature side) cancel temperature
Final toner concentration sensor output value
Desk 2/LCC 2 paper feed counter Toner concentration temperature correction
(high temperature side) correction quantity
Toner cartridge IC chip destination
Manual paper feed counter Toner concentration temperature correction
(high temperature side) judgment temperature
Counter mode setup
ADU paper feed counter Toner concentration temperature correction
(high temperature side) judgment voltage difference
White paper exit count setup
Staple counter Toner concentration temperature correction
(high temperature side) correction value
Trouble memory mode setup
Punch counter Toner concentration temperature correction
(low temperature side) cancel temperature
Fusing operation mode (anti-curling)
Machine right side paper exit counter Toner concentration temperature correction
(high temperature side) toner control delay time
CE mark conforming operation mode
Multi-purpose width adjustment value Maintenance cycle
Manual feed width adjustment value Print stop setup at developer life over
Heater lamp temperature (center, normal control) Saddle alignment operation priority mode
Lead edge adjustment
Lead edge void set value
Rear edge void set value
Side edge setup
Print off-center adjustment value
Resist quantity adjustment value
Laser power adjustment value
PPD1 sensor adjustment
Process correction inhibit allow setup value
Developing bias rising correction wait time
Developing bias rising correction adjustment value
Built-in finisher jogger position adjustment
Saddle adjustment value
 '   ! "#$%&