Sharp AR-M450 - Page 51

AR-M350 MACHINE OPERATION 8-4
Account
control
Auditing mode ON/OFF*
Print per account Print per account display ON*/OFF
Print per account print
Reset account
Account number control Enter new account number(5digits)
Delete account number
Change account number
Print account number
No print if acc't # invalid Yes/No*
Energy save Auto power shut-off timer 15min/30min*/60min/120min/240min
Auto power shut-off Disable/Enable*
Preheat mode 15min*/30min/60min/120min/240min/None
Toner save ON/OFF*
Operation
panel settings
Auto clear setting 15sec/30sec/60sec*/OFF
Message display time 3sec/6sec*/9sec/12sec
Language setting American English/English*/French/Spanish Depend on the
distination
Device
settings
Disable duplex unit Yes/No*
Disable stapler unit Yes/No*
Disable paper desk
drawers
Yes/No*
Disable finisher Yes/No*
Disable mail-bin stacker Yes/No*
Saddle stitch adjust Paper size A4 -3.0mm~0.0mm*~3.0mm (0.1mm unit) With the
saddle finisher
installed
Paper size B4 -3.0mm~0.0mm*~3.0mm (0.1mm unit)
Paper size A4R -3.0mm~0.0mm*~3.0mm (0.1mm unit)
Paper size Ledger -3.0mm~0.0mm*~3.0mm (0.1mm unit)
Paper size Letter-R -3.0mm~0.0mm*~3.0mm (0.1mm unit)
Print key
operator
program list
Key operator
code change
Set code 00000*
System
settings
Default settings Print density level Normal*/DAKER/DARKEST/LIGHTEST/LIGHTER
Disable notice page printing Yes*/No
Disable test page printing Yes*/No
A4/LT auto select ON/OFF*
Interface settings Hexadecimal dump mode ON/OFF*
PDL for parallel port Auto*/PostScript/PCL
PDL for network port Auto*/PostScript/PCL
I/O timeout 1sec~20sec*~999sec
Port switching Per job*/Timeout/Paralell OFF/Network OFF
Network settings IP address setting IP address 000.000.000.000*
IP subnet mask 000.000.000.000*
IP gateway 000.000.000.000*
Enable TCP/IP Yes*/No
Enable NetWare Yes*/No
Enable EtherTalk Yes*/No
Enable NetBEUI Yes*/No
Reset the NIC
Intialize/Store settings Restore factory defaults
Store current configuration
Restore configuration
Product key PS3 expansion kit
E-mail alert and status
KEY OPERATOR PROGRAM
Set value(Default)
Remark
Engine section LCD
 )   ! "#$%&