Sharp AR-M550N - Page 191

AR-555/550/620/625 SIGNAL NAME LIST / 信号名リスト 7 - 7
PNC-a Count-up signal (Personal
counter)
Count up (Personal counter)
220
PCU
POD1 Paper exit detection 1 signal Paper exit detection from
fusing
Paper pass — 53
PCU
POD2 Paper exit detection 2 signal Paper pass detection from
paper exit
Paper pass — 59
PCU
POD3 Paper exit detection 3 signal Paper exit detection to upper
section paper exit tray (Full
detection)
Paper pass — 515
PCU
POF Power OFF status signal Power OFF status Power OFF Power ON 9 3 PCU
POF_SCN Power off signal Power OFF status signal
(Output from PCU)
Power OFF 9 43
SCN
POM1A Paper exit motor 1 (Fusing
side) control signal (Phase A)
Paper exit unit (Fusing side)
paper transport
——10 1
PCU
POM1B Paper exit motor 1 (Fusing
side) control signal (Phase B)
Paper exit unit (Fusing side)
paper transport
——10 3
PCU
POM1XA Paper exit motor 1 (Fusing
side) control signal (Phase /A)
Paper exit unit (Fusing side)
paper transport
——10 2
PCU
POM1XB Paper exit motor 1 (Fusing
side) control signal (Phase /B)
Paper exit unit (Fusing side)
paper transport
——10 4
PCU
POM2A Paper exit motor 2 (Paper exit
side) control signal (Phase A)
Paper exit unit (paper exit side)
paper transport
——10 5
PCU
POM2B Paper exit motor 2 (Fusing
side) control signal (Phase B)
Paper exit unit (paper exit side)
paper transport
——10 7
PCU
POM2XA Paper exit motor 2 (Fusing
side) control signal (Phase /A)
Paper exit unit (paper exit side)
paper transport
——10 6
PCU
POM2XB Paper exit motor 2 (Fusing
side) control signal (Phase /B)
Paper exit unit (Paper exit side)
paper transport
——10 8
PCU
PPD Resist roller front paper pass
detection signal
Paper pass detection in front of
resist roller
Paper pass — 12 15
PCU
PROFF_CNT BUP-PR control signal (Main
power OFF signal)
Main power OFF signal (output
from controller)
— End 9 4
PCU
PRON_FAX BUP-PR control signal (Main
power ON signal)
Main power ON signal (Output
front FAX unit)
Boot — 91
PCU
PSBC Resist roller brake clutch
control signal
Resist roller brake clutch
control —
Paper
transport
enable
12 11
PCU
PSPS Separation solenoid control
signal
Separation solenoid control
Separation — 813
PCU
READY LSU motor lock detection
signal
LSU motor lock detection
Rotation Stop/Lock 22 5
PCU
READY Copy enable signal (Auditor) Copy enable (Auditor) Copy
enable
54
SCN
RES_CCD Reset signal (CCD) Reset (CCD) Reset 1 64 SCN
RES_CIS Reset signal (CIS) Reset (CIS) Reset 10 15 SCN
RES_FIN Finisher reset signal Finisher reset Operation
enable
Reset 17 19
PCU
RES_LCC LCC reset signal LCC reset Operation
enable
Reset 18 11
PCU
RES_MFP Main unit reset signal (MFP) Not used. Reset 9 12 SCN
RES_SCN Scanner reset signal Scanner reset (output from
controller)
Reset 9 44
SCN
RRC Resist roller clutch control
signal
Resist roller clutch control (The
relative position of print image
and paper is controlled.)
Paper
transport
— 74
PCU
RTH1 Heat roller temperature
detection signal
Heat roller temperature
detection
——26
PCU
RTH2 Pressure roller temperature
detection signal
Pressure roller temperature
detection
——210
PCU
RTH3 Sub heat roller temperature
detection signal
Sub heat roller temperature
detection
——214
PCU
RXD_CCD1 Serial I/F data (CCD) Serial I/F data (CCD-scanner
control PWB)
——165
SCN
RXD_CCD2 Serial I/F data (CIS) Serial I/F data (CCD-scanner
control PWB)
——10 16
SCN
Signal name Name Function/Operation
Connector level
Connector
No.
Pin No.
PWB
name
Remark
"L" "H"