SELECTING PRINTING FUNCTIONS Settings in the [Main] tab (continued)
2-4
Finishing
Configure settings for staple or punch finishing.
[Binding Edge]
When automatic two-sided printing is performed,
the [Binding Edge] setting is used to determine
how the top and bottom edges of the front and back
sides are positioned. The relation between the
document and each of the settings is as follows:
Default setting: Left
[Staple]
[None] ............ Do not staple.
[1 Staple]........ Staple in one place.
[2 Staples] ...... Staple in two places.
Default setting: None
Pamphlet stapling function
The paper is stapled in two places at the centreline,
folded in half as shown, and delivered to the output
tray.
Staple sort function
Each set of pages printed using the sort function is
stapled and delivered to the top tray, or stapled at
the centre and delivered to the lower pamphlet tray.
(Saddle stitch finisher only) The relations between
stapling positions, paper feed orientations, allowed
paper sizes, and stapling limits are indicated
below.
Possible stapling positions
6
Original image
Binding edge
[Left]
Left binding
Binding edge
[Right]
Rignt binding
Binding edge
[Top]
Top binding
9
11
7
2
4
6
[Example]
Vertical paper feeding
One staple
at top left
corner
Possible paper sizes: A4, B5,
8-1/2" x 11"
Staple limit: 50 sheets
One staple
at bottom
left corner
Same as above
Two staples
at left edge
Same as above
Two staples
at centreline
Pamphlet style is not possible
using vertically fed paper
Horizontal paper feeding
One staple
at top left
corner
Possible paper sizes: A3, B4, 11" x
17"
Staple limit: 30 sheets
Possible paper sizes: A4R, 8-1/2"
x 14", 8-1/2" x 13", 8-1/2" x 11"R
Staple limit: 30 sheets
One staple
at bottom
left corner
Possible paper sizes: A3, B4, A4R,
11" x 17", 8-1/2" x 14", 8-1/2" x 13",
8-1/2" x 11"R
Staple limit: 30 sheets
Two staples
at left edge
Same as above
Two staples
at centreline
Possible paper sizes: A3, B4, A4R,
11" x 17", 8-1/2" x 14", 8-1/2" x 13",
8-1/2" x 11"R
Staple limit: 15 sheets
To Next Page
Loading...
