E-9
ENGLISH
PLASMACLUSTER OPERATION
The Plasmacluster Ion generator inside the air
conditioner will release positive and negative
plasmacluster ions into the room.
Approximately the same numbers of positive
and negative ions released into the air will
reduce some airborne mold.
1
During operation, press the
PLASMACLUSTER button.
• The remote control will display “ ”.
• The blue PLASMACLUSTER lamp on the
unit will light up.
TO CANCEL
Press the PLASMACLUSTER button again.
• The PLASMACLUSTER lamp on the unit will turn
off.
NOTE:
• Use of the PLASMACLUSTER operation will be
memorized, and it will be activated the next time
you turn on the air conditioner.
• To turn off the PLASMACLUSTER lamp, press
the DISPLAY button.
• To perform Plasmacluster operation in FAN only
mode, press the PLASMACLUSTER button when
the unit is not operating.
The mode symbol of the remote control will go off
and the fan speed cannot be set to AUTO.
SELF CLEAN OPERATION
SELF CLEAN operation will reduce the growth
mold fungus with Plasmacluster ions and dry
inside of the air conditioner unit. Utilize the
operation at seasonal change over terms or
every 4 months.
Mold fungus already grown can not be
eliminated by this operation.
1
Press the SELF CLEAN button when
the unit is not operating.
• The remote control displays “ ”.
• The blue PLASMACLUSTER lamp on the unit
will light up.
• The unit will stop operation after forty minutes.
TO CANCEL
Press the SELF CLEAN button.
Alternatively, turn the unit off by pressing the
ON/OFF button.
• The blue PLASMACLUSTER lamp on the unit will
turn off.
NOTE:
• You cannot set the temperature, fan speed, air
fl ow direction or timer setting during the SELF
CLEAN operation.
1
1
To Next Page
Loading...