Sharp AY-XPC12PU - Page 27

AY-XPC12PU
5 – 5
19
)
Loosen the screw fixin
g
terminal board,
21
)
Pull PWB toward b
y
the direction
shown in the picture.
18) Loosen 2 screws and remove
LED holder .
side cover R .
20) Push the hook and reverse
22
)
Lift the hook and remove LED PWB .
Hook
23) Remove the center shaft of
horizontal louver from louver holder
with lifting the louver holder, and
remove the left shaft of
while warping.
horizontal louver from drain pan
and take terminal board up.