Sharp AY-XPC12PU - Plasmacluster Unit

AY-XPC12PU
5 – 6
25) Loosen 3 screws fixing stabilizer R
,
then remove stabilizer R .
28) Remove horizontal louver, loosen
the screw and remove louver motor .
24) Loose 1 screws of guard holder for wire
guard, and then take off guard holder.
Unhook the wire guard as shown below,
and then take off wire guard.
(Same as left side.)
plasmacluster ass'y and remove
plasmacluster unit .
27) Push 3 hooks, open
Hook
26) Cut the fixing band and remove
plasmacluster ass'y .
Hook