20
BEFORE USING THE MACHINE
LOAD PAPER INTO THE TRAY 2 - 4
1
Pull out the paper tray.
Gently pull the tray out until it stops.
To load paper, go to step 3. To load a different size of paper,
go to the next step.
2
Adjust guide plates A and B to match
the longitudinal and transversal
dimensions of the paper to be loaded.
The guide plates A and B are slidable. Squeeze the
separator plate lever and slide to the desired paper size.
3
Insert the paper into the tray.
Load the paper with the print side facing up. The stack must
not be higher than the indicator line (Maximum of 500
sheets).
• If a paper misfeed occurs, turn the paper over and/or around, and reload.
• If the paper is curled, fix the curl before loading the paper.
• Adjust the divider plate so that there is no gap between the paper and divider plate.
• Do not add paper.
• Do not load the paper as shown below.
4
Gently push the paper tray into the
machine.
Push the tray firmly all the way into the machine slowly.
Forcefully inserting the paper may cause skewed feeding
and paper misfeeds.
To Next Page
Loading...
Need help?
General
