BEFORE USING THE MACHINE
11
PLACING ORIGINALS
The automatic document feeder can be used to automatically scan many originals at once, and this saves you the
trouble of manually feeding each original.
For originals that cannot be scanned using the automatic document feeder, such as a book or a document with notes
attached, use the document glass.
USING THE AUTOMATIC DOCUMENT FEEDER
When using the automatic document feeder, place the originals in the document feeder tray.
Make sure an original has not been placed on the document glass.
Loading a Business Card (BP-55C26/BP-70C31/BP-70C36/BP-70C45/
BP-70C55/BP-70C65)
When scanning a business card with the automatic document feeder, align the original guide to the size of the card.
USING THE DOCUMENT GLASS
Take care that your fingers are not pinched when closing the automatic document feeder.
After placing the original, be sure to close the automatic document feeder. If left open, parts outside of the original will be
copied black, causing excessive use of toner.
Adjust the original guides
to the width of the originals.
Place the originals face up with the edges aligned
evenly.
The indicator line indicates approximately
how many originals can be placed. The placed originals
must not be higher than this line.
Place the original face down.
Align the top left corner of the
original with the
tip of the mark in the far left corner
of the glass.
Place the original
face down.
To Next Page
Loading...
