Sharp CD-JX20X(GY) - Removing and Reinstalling the Main Parts

REMOVING AND REINSTALLING THE MAIN PARTS
TAPE MECHANISM SECTION
Perform steps 1, 2, 3, 4, 5, 6, and 7 of the disassembly method
to remove the tape mechanism.
Main/FF, Rewind Belt (See Fig. 16-l.)
1. Remove the main belt, (Al) x I PC., at the tape 2 side from
the motor pulley.
2. Remove the main belt, (A2) x 1 PC., at the tape 1 side from
the motor pulley.
3. Remove the FF/Rewind belt, (A3) x 2 PCS., from the FF/Re-
wind roller.
4. Put on the belts in the reverse order of removal.
Note:
1. When putting on the belt, ascertain that the belt is not
twisted, and clean it.
FWD fl
REV fiywheel
FWD flywheel
Figure 16-l
- (Bl)X2
,I---!
$2X4mm
.a_*_-
Motor
Motor (See Fig. 16-2, 3)
1. Remove the screw, (Bl) x 4 PCS., and remove the motor
fixture.
2. Remove the screw, (B2) x 3 PCS., and remove the motor.
Note:
1. When mounting the motor, pay attention to the motor
mounting angle.
2. When the motor is removed, the belt comes off. Put it on,
referring to the description of belt putting-on.
Switch PWB (See Fig. 16-4.)
1. Remove the screw, (Cl) x 2 PCS,, and remove the switch
protecting plate.
2. Remove the screw, (C2) x 1 PC., remove solder joint of
solenoid, (C3) x 4 PCS., and remove the switch PWB.
Note:
1. When mounting the PWB, ascertain that the photocoupler
transistor does not contact the magnet on the reel stand
and keep in mind that the switch exists between it and
FFlRewind lever.
Figure 16-2
Motor mounting.
bracket
Motor
Figure 16-3
Switch protect&
board
Switch PWB
Figure 16-4
-16-