Sharp CD-JX20X(GY) - CD Mechanism Section

How to remove the flywheel (See Fig. 17-1.)
1. Remove the drive belt.
2. Remove the stop washer (Dl) with a small precision screw-
driver to extract the flywheel from the capstan metal.
Note:
1. When the stop washer is deformed or damaged, replace it
with a new one.
Pinch Roller (See Fig. 17-2.)
1. Carefully release the pinch roller dog in the direction indi-
cated by the arrow mark @ ,and remove the pinch roller,
(El) x 1 PC., upward.
Removing the Record/Playback/Erase Head
(See Fig. 17-2, 4.)
1. Remove the screw, (Fl) x 2 PCS., and remove the head
base.
2. Remove the screw, (F2) x 2 PCS., and remove the head.
Cares When Mounting the Head
Mount the head in the position shown in Fig. 17-4.
Be sure to apply screw lock after replacement of head and
azimuth adjustment.
CD MECHANISM SECTION
Removing the optical pickup(See Fig. 17-5.)
1. Remove 4 pawls (Gl) and remove cover (G2).
2. Remove 4 screws (G3) and remove 2 shafts (G4).
Clamp
(Gl)
X
(G3IX2
02.6 X8mm
(G2)xl
G3IX2
02.6x8mm
Figure 17-1 Flywheel
Pinch roller
\ n
Figure 17-2
metal
roller
,r-. 1” *
7
(F2)x 2
11.6X5mm
spin
Figure 17-3
Tape Guide
0
m
I
0
Tape I
Tape 2
Figure 17-5
-17-
Figure 17-4