Sharp CD-JX20X(GY) - Specifications; Ac Power Supply Cord and Plug

l General
Power source:
Output power:
Speakers:
Input impedance:
Load impedance:
Dimensions:
Weight:
0 Radio section
Frequency range:
FOR A COMPLETE DESCRIPTION OF THE OPERATION OF THIS UNIT, PLEASE
REFER TO THE OPERATION MANUAL.
SPECIFICATIONS
AC 240 V, 50 Hz (For Australia)
AC 110 V, 60 Hz (For Taiwan)
AC 220 V, 50160 Hz (For other
areas)
DC 15 V [“D” size (UMSUM-1,
R20 or HP-2) battery x lo]
DC 3 V [“AA” size (UMSUM-3,
R6 or HP-7) battery x 2 for
clock/memory battery]
PMPO; 40 W (20 W + 20 W)
(AC operation)
MPO; 28 W (14 W + 14 W) (AC
operation)
RMS; 15 W (7.5 W + 7.5 W) (DC
operation, 10% distortion)
10 cm (4”) full range speaker x 2
Mixing mic; 600 ohms
Auxiliary in; 50 k ohms
Headphones; 16-50 ohms (recom-
mended 32 ohms)
Width; 580 mm (22-13/16”)
Height; 195 mm (7-l l/16”)
Depth; 238 mm (9-318”)
6.5 kg (14.3 Ibs.) without batteries
FM; 88-108 MHz (100 kHz span)
AM; 531-1,602 kHz (9 kHz span)
AC POWER SUPPLY CORD AND PLUG
0 Tape deck section
Tape:
Compact cassette tape
Motor:
DC motor x 1
Head:
TAPE-l: Playback x 1
TAPE-2: Record/playback x 1
Erase x 1
Tape speed: 4.76 cm/set (l-7/8 ips.)
Bias and erasure system: AC
@ Compact disc player section
Type:
Compact disc player
Signal readout:
Non-contact, 3-beam semi-conduc-
tor laser pickup
Rotational speed: 200 - 500 rpm CLV, Approx.
Error correction: CIRC (Cross Interleave Reed-So-
lomon Code)
Audio channels: 2
Decoder: i6-bit linear quantization
Filter:
4 times oversampling 16 bit digi-
tal filter
Frequency response: 20 - 20,000 Hz(+i/-3 dB)
Wow and flutter:
Unmeasurable (less than 0.001%
W. peak)
Specifications for this model are subject to change without
prior notice.
QACCL0059AFOO (For Australia) . QACCK0053AFZZ (For other Areas)
QACCZb062AFOO (For Taiwan)
CAUTIONS ON HANDLING THE UNIT
l Dew condensation
You know such phenomenon that, in winter, a windowpane
of the heated room develops some amount of dews on its
surface. This phenomenon of dew condensation may also
occur at the object lens in the pickup unit in the following
instances.
l
When the compact disc player is operated immediately after
you have turned on a heating device in your room.
l When it is operated in a room full of wet air (with steam
or moisture).
l When it is operated in a warm place to which it has been
moved from a rather cold place.
If the object lens has some amount of dew condensed on
it, the compact disc player may fail to operate correctly as
it can’t read out the information data recorded on the disc
surface. If such occurs, remove the compact disc from the
disc table, turn on the power switch and leave the unit for
some time (about 1 hour at the longest); then it will resume
its normal operation.
-2-