Sharp CD-PC651H

(Main unit operation)
in this example, the clock is set for the
24-hour (0:00) system.
CLOCK
ON/
STAND-BY
MEMORY/
SET
Nn es ne A
it. fat Ly
2
es
Oe
al
cee
tf
V \ 1 ¢ 4
ra ar
3
ee
|
ee eee fee ee ee ee
VV I ¢ 4
A rn
Litt
ee i
0:00<— AM 0:00 <— AM 12:00
ea Saree
, |oé@
5 mmr
Oe i ER |
a EE
6 . |?
iit tia
PE feel
a
7 , lo?
Te ee oe ae |
PL LtLd
a ee ee ye
,oii¢
[Tae ta
8
(it
Ss
a So ion
\I/
a a oan i a
9 ti [
Lo
r
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Press the CLOCK button.
3 Within 5 seconds, press the MEMORY/SET button.
A Press the TUNING/TIME (\v or A) button to select ihe time
display mode.
"0:00" — The 24-hour display wil! appear.
(0:00 - 23:59)
“AM 0:00" — The 12-hour display will appear.
(AM 0:00 - PM 11:59)
"AM 12:00" > The 12-hour display will appear.
(AM 12:00 - PM 11:59)
@ Note thai this can only be set when the unit is first installed
or it has been reset (see page 30).
5 press the MEMORY/SET button.
6 Press the TUNING/TIME (vy or A) button to adjust the hour.
@ Press the TUNING/TIME (\v or A) button once to advance
the time by 1 hour. Hold it down to advance continuously.
@ When the 12-hour display is selected, "AM" will change auto-
matically to “PM”.
7 Press the MEMORY/SET button.
8 Press the TUNING/TIME (xv or A) button to adjust the
minutes.
@ Press the TUNING/TIME (v or A) button once to advance
the time by 1 minute. Hold it down to change the time in 5
minute intervals.
@ The hour setting will not advance even if minutes advance from
"5Q" io "OO"”
9 press the MEMORY/SET bution.
@ The ciock starts operating from "0" seconds.
(Seconds are not displayed.)
To see the time display:
Press the CLOCK button.
@ The time display will appear for about 5 seconds.
Note:
@ The clock display will flash on and off at the push of the CLOCK
button when the AC power supply is restored after a power
failure occurs or after the AC power lead is disconnected.
lf this happens, follow the procedure below to change the clock
time.
To change the clock time:
D Press the CLOCK button.
@ within 5 seconds, press the MEMORY/SET button.
Perform steps 6 - 9 above.
To change the time display mode:
@ Perform steps 1 - 2 in the section "RESETTING THE MICRO-
COMPUTER", on page 30.
@) Perform steps 1 - 9 above.
E-10