Sharp CD-PC651H

=) ={e10)=1 8) 1) (C)
@ When recording important selections, be sure to
make a.preliminary test to ensure that the desired
material is being properly recorded.
@ The volume and sound effect controls may be ad-.
justed with no effect on the recorded signal. (Variable
Sound Monitor)
REC PAUSE BH Rc
TAPE 1 TAPE2
CDl
TAPE @
TAPE2 >
TAPE(1~2)
TUNER
(BAND)
Mi Recording from the built-in radio
1 Tune in to the desired station. (See pages 16-17.)
2 Load a cassetie into the TAPE 2 cassette compart-
ment.
3 Press the REC PAUSE (@ II) button.
@ "REC" will flash.
4 Press the /< (TAPE 2 }) button.
@ "REC" will appear.
Note:
@ (f a whistling noise is heard whilst recording from an
AM station, move the AM loop aerial to a position
where noise is no tonger heard from the unit.
To stop recording:
Press the Ml (TAPE @) button.
@ Metal and CrOz tapes should not be used for recording or
dubbing.
@ To erase a recorded tape, press the TAPE (1 — 2) bution to
select TAPE 2, press the REC PAUSE (@ EB) button, and
finally press the / < (TAPE 2 b) button.
(Check to make sure that TAPE 7 is not being used.)
i Recording from the built-in CD player
(CD Synchronised Recording System)
1 Press the ON/STAND-BY button to turn the power on.
2 Press the CD button and load the desired disc.
@ Use ihe APMS function to store the tracks you want to record
in memory. (See page 715.)
3 Load a cassette into the TAPE 2 cassette compartmeni.
4 Press the REC PAUSE (@ HI) button.
@ "SYNC" and "REC" will flash.
5 Press the /< (TAPE 2 >) button.
@ "REC" will appear.
@ CD playback will start approximately 5 seconds after the tape
Starts.
To stop recording:
Press the li (CD Wi) button.
The CD and tape will stop.
Note:
@ When the end of the tape is reached whilst recording, the CD
player will display the track number which was being played
at that time, and stop automatically.
if you want to restart recording from the interrupted track, turn
over the tape, press the REC PAUSE (@ —II) button and then
the /— (TAPE 2 }} button.
(If tracks have been stored in memory using the APMS func-
tion, recording will restart from the first track stored in mem-
ory.)
Mi Dubbing from tape to tape
1 Press the ON/STAND-BY buiton to turn the power on.
2 Load a prerecorded cassette into the TAPE 1 cassette com-
partment. Insert a blank tape into the TAPE 2 cassette com-
partment.
@ lt is recommended that the recording tape be the same length
as the master tape. ;
3 Press the TAPE (1 —2) button until "TAPE 1" appears in the
display.
4 Press the REC PAUSE (@ II) button.
5 Press the ® /& (TAPE 2 P) button.
To stop dubbing:
Press the Mf (TAPE Ml) button.
@ TAPE 1 and TAPE 2 will simultaneously stop.
E-27