Sharp CD-PC651H

HOW TO USE THE BUILT-IN TIMER
(Main unit operation)
MEMORY/SET
TIMER/
SLEEP
ON/
STAND-BY
CD
TAPE
(1-2)
VIDEO
AUX
TUNER
(BAND)
3
li Sleep operation
The radio, compact disc and cassette deck can all be
turned off automatically.
1 Play back the desired sound source.
2 Press the TIMER/SLEEP button repeatedly until
“SLEEP" is displayed.
To change the sleep time:
Whilst the sleep time is displayed, press the TUN-
ING/TIME (7 or A} button to adjust the time.
(Maximum: 3 hours - Minimum: 1 minute)
The amount of sleep time can also be changed during
the sleep operation.
@ 3 hours - 5 minutes — 5-minute intervals
@ 5 minutes - 1 minute 3 1-minute intervals
3 Press the MEMORY/SET button.
4 The unit will turn off automatically after the preset
sleep time has elapsed.
Note:
@ Once ihe sleep time is set, it will remain ihe same
duration until the setting is changed.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button.
To cancel the sleep operation:
Press the ON/STAND-BY button to enter the stand-by
mode.
@ Timer playback
@ Before setting the timer, make sure that the clock setting is
correct. (Page 10)
1 Press the ON/STAND-BY button to turn the power on.
2 Press the CD, TUNER (BAND), TAPE (1—2) or VIDEO/AUX
button to select the desired function.
3 Press the TIMER/SLEEP button repeatedly until a green “e"
is displayed.
@ The timer set indicator will flash.
4 Press the TUNING/TIME ( or A) button to set the hour
start time, then press the MEMORY/SET button.
5 Press the TUNING/TIME (\v or A) button to set the minute
start time, then press the MEMORY/SET button.
@ The power will be automatically turned off, and the timer set
indicaior will light up.
6 When the preset time is reached, the volume will increase
gradually until it reaches the volume you were listening to
before turning off the unit.
7 lf you select CD or TAPE during timer playback, the power
will be turned off after the tape or CD is finished playing back.
If you select TUNER or VIDEO/AUX, the power will be turned
off one hour later.
i Timer recording
1 Press the ON/STAND-BY button to turn the power on.
@ Load a cassette for recording into the TAPE 2 cassette com-
partment.
2 Press the TUNER (BAND) or VIDEO/AUX button to select the
desired function.
3 Press the TIMER/SLEEP button repeatedly until a red "®" is
displayed.
@ The timer set indicator will flash.
4 Press the FUNING/TIME (\v or A) button to set the hour start
time, then press the MEMORY/SET button.
5 Press the TUNING/TIME (vv or A) button to set the minute
start time, then press ihe MEMORY/SET button.
@ The power will be automatically turned off, and the timer set
indicator will light up.
6 When the recording tape reaches its end, the timer recording
will end, and the power will be turned off.
@® When timer recording starts, the volume will increase gradually
until it reaches ihe volume you were listening to before turning
off the unit.
To cancel timer operation:
Press the ON/STAND-BY button to turn ihe power on.
To change the programmed contents:
Start again from step 1.
Note:
@ Once the time is set, the setting will be retained unti! a new
time is entered.
E-28