6
GT
GRAND TOTAL MODE SELECTOR:
“GT”: This selector will accumulate the
following:
(“ ✱ +” will be printed.)
1. Addition and subtraction totals
obtained with
.
2. Product and quotient totals
obtained with
or .
3. Answers obtained with
or
.
“•”: Neutral
PAPER FEED KEY
LAST DIGIT CORRECTION KEY
GRAND TOTAL KEY:
Prints and clears the “GT” memory
contents.
NON-ADD / SUBTOTAL KEY:
Non-Add – When this key is pressed
right after entry of a
number in the Print mode,
the entry is printed on the
left-hand side with “#”.
This key is used to print
out numbers not subject to
calculations such as
codes, dates, etc.
Subtotal – Used to get subtotal(s) of
additions and/or subtrac-
tions. When pressed
following
or , the
subtotal is printed with “
◊
”
and the calculation may be
continued.
By pressing this key even in the
Non-print mode, the displayed
number is printed with “P”.
TOTAL KEY:
Prints the total of addition and
subtraction with “ ✱ ”.
This key also serves as a clear key for
the calculation register and resets an
error condition.
CLEAR ENTRY KEY:
Clears numbers entered prior to use of
a function key.
Also used to clear an overflow error
caused by an entry.
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
Need help?
General
