Sharp CV10CTXB - Energy Efficiency Tips; Operating Conditions; Notes on Operation; Precautions

EN-6
PRECAUTIONS
NOTES ON OPERATION
•Allow3minutesforthecompressortorestartcooling.
If you turn the unit off and immediately restart it, allow three minutes for the compressor
to restart cooling. There is an electronic device in the unit that keeps the compressor
turned off for three minutes for safety.
•Intheeventofapowerfailureduringuse,allow3minutesbeforerestartingtheunit.
After power is reinstated, restart the unit. If the power was off for less than three min-
utes, be sure to wait at least three minutes before restarting the unit. If you restart the
unit within three minutes, a protective device in the unit may cause the compressor to
shut off. This protective device will prevent cooling for about 5 minutes. Any previous
settings will be cancelled and the unit will return to its initial settings.
•Lowtemperatureoperation:Isyourunitfreezingup?
Freezing may occur when the unit is set close to 64°F in low ambient temperature con-
ditions, especially at night.
In these conditions, a further temperature drop may cause the unit to freeze.
Setting the unit to a higher temperature will prevent it from freezing.
•Dehumidicationmodeincreasesroomtemperature.
The unit generates heat during dehumidication mode and the room temperature will
rise.WarmairwillbeblownoutfromtheExhaustairoutlet,butthisisnormalanddoes
not indicate a problem with the unit.
•This unit blows the warm air generated by the unit outside the room via the ex-
haust hose while in cool mode.
Accordingly, the same amount of air as that is blown out will enter the room from
outside through any openings into the room.
•When cooling operationisperformed at high humidity conditions, water tank in-
side the unit may frequently become full.
 Whenwater tank inside the unitis full, theunit stops operatingBuzzer willsound 8
times,LED windowshow error codeH8. Inthis case, performdrainage todrain out
water within the unit.
OPERATING CONDITIONS
•Theunitmustbeoperatedwithinthefollowingtemperaturerange.
Mode Room temperature
Cool 64°F - 95°F
•Abuilt-insafetydevicemaycutoffoperationifthetemperatureexceedstheselimits.
ENERGY EFFICIENCY TIPS
•Avoiddirectsunlight.
Close blinds, drapes or shades to keep out direct sunlight while in cooling mode.
•Keepthelterclean.
 Keepingtheltercleangreatlyaidsefcientoperation.Adirtylterblockstheowof
air, making your unit work harder and less efciently.
•Turnoffunnecessarylights.
 Yourunitmustremovetheheatproducedbyyourlightsorotherheat-producingappli-
ances. Turn off any lights or appliances that are not in use.